top of page
『Recovery Device・Stand』operating instructions.
Please be aware of the following when using this product.
This product is primarily produced using a 3D printer. Unlike typical molded products, there are some weaker areas. Applying excessive force may cause damage. Please handle with care. There may also be traces of lamination and burrs. We have done our best to remove these, but if there are any areas that concern you, please clean them up yourself.
- Two types of USB cables are included.
The USB cable with the "AtoC Power input" sticker should be used as the power input.
The cable with Type-C on both ends and no sticker is used to connect the base (bottom) and top cover (top).
Tip: Use at 5V 2A or less. Mobile batteries and other devices may have a protection circuit that prevents the light from turning on, or may turn off after a few seconds. We strongly recommend powering the device from a Type-A USB port.
- There are two USB ports on the back of the base (bottom). Connect the power input cable to one of them. Connect the cable for connecting to the top cover (top) to the other.
- Connect the Type-C cable connected to the base to the USB port on the back of the top cover.
- Peel off the protective paper with the "Remove" sticker attached to each location.
- Insert the included battery (CR-2025 x 1) into the remote control. Instructions for insertion are on the back of the remote control.
・After connecting the USB cable for power input to the main unit, point the remote control at the light-emitting part and operate it.
Tip: If you want the top and bottom LEDs to light up in the same color, you can operate both the top and bottom LEDs simultaneously by holding the remote control horizontally between the top and bottom light-emitting parts. (We recommend performing the above operation while holding the remote control about 30 cm away from the main unit.)
・ Place the doll on the stand.
Tip: Adjust the upper and lower flexible arms to a certain position and then place the doll. It may seem difficult at first until you get used to it, but after doing it a few times you will get used to adjusting the position.
- The support pillars at the base of the stand are subjected to a large load. In places with high temperatures, they may become deformed due to heat. Please refrain from using them in high temperature environments.
Tip: Please avoid storing the doll with its feet raised for long periods of time. When storing for long periods of time, we recommend keeping the feet flat on the base. Also, if the support pillars become damaged, please replace them with the spare pillars provided.
・The screws indicated by the red arrows may become loose when moved. Use the included wrench to tighten them appropriately.
Tip: Adjust the screw tightness so that there is an appropriate amount of resistance to movement. Take care not to overtighten the screws, as this may cause damage.
bottom of page