How to incorporate 「Chair 円」
・The seat and caster arm are not fixed.Never lift by grasping only the seat surface.Please be careful.Be sure to grasp the entire caster arm with both hands and lift it up.please.
- Although the surface of this product has been lightly treated after being printed on a 3D printer, there are some lamination marks and chips. note that.
-This product is designed to withstand the weight of one doll, but there is a risk of damage if excessive force is applied. Please handle with care.
・Please clean with a dry or damp cloth. Do not wipe with thinner or mirror activator.
・Do not leave the product in direct sunlight or in high temperatures for long periods of time. Doing so may cause deformation or damage due to heat.
・With the doll on itIf it lasts for more than 12 hours, be sure to set the included pedestal.please.
*The caster arm part is made of nylon material containing carbon fiber with 100% density. Although the material is relatively heat and strength resistant, we recommend storing it with the pedestal attached as much as possible to avoid deforming the arm.
❶ Check if the parts are ready.
Ⓒ The lever is a dummy. It is not movable. Please be careful not to apply strong force.
The caster arm and seat can be separated. The caster arm cannot be disassembled, so please be careful not to allow foreign objects to enter the rotating part.
Do not apply grease to rotating parts. The rotation will become slower. For maintenance, just spray one push of spray-type silicone oil.
*Rotating parts are basically maintenance-free.
When inserting the seat shaft into the caster arm, be sure to make sure it is clean.
*After applying a small amount of spray-type silicone oil to the shaft, wipe it off with a rag.
